Optimasi Proses Injeksi Dengan Metode Taguchi

Didik Wahjudi • Gan Shu San • Yohan Pramono
Journal article Jurnal Teknik Mesin Universitas Kristen Petra • April 2001 Indonesia

Unduh teks lengkap
(Bahasa Indonesia, 5 pages)


At this time about 3% of products produced by "X" plastic factory does not reach the standard. This factory has a problem to minimize the amount of defects. Taguchi method is used to lower the level of product defects. From the field survey, all the suspected factors can be obatained and it is shown ini the fishbone diagram. From the suspected factors, the factory chose factors that are to be used ini the experiments. Experiments were conducted using those four factors : pellet material percentage (60%, 70%, 80%), temperature (217°C, 225°C, 233°C), injection pressure (92 Bar, 93 Bar, 94 Bar), screw speed (81%, 83%, 85%). Taguchi method provide the combination and number of experiments. From each level of defects condition, analysis was done to obtain the affecting variables. The results of analysis shows that the combination of pellet material (80%), temperature (225°C), injection pressure (93 Bar), screw speed (83%) can minimize the amount of defects to 0.3%.


  • 232 kali dilihat
  • 1591 kali diunduh


Jurnal Teknik Mesin Universitas Kristen Petra

Jurnal Teknik Mesin Universitas Kristen Petra is an open access, peer-reviewed journal that publi... tampilkan semua